Checking Original Shaft With Worn Shaft Replaced For Run Out And Vibration
Автор: 29 Chev Bolens Channel
Загружено: 2026-02-03
Просмотров: 82
Описание:
Caution: If you chose to duplicate this set up you do so at your own risk! A spinning shaft can come loose if not properly mounted and could cause injury or death!
In this video I have placed the original shaft off of my Bolens Lawn Mower Deck with the repaired yoke back in the lathe after replacing the piece of rectangular shaft that was worn at the slip yoke end with a new piece. The original shaft was worn approximately .010" to .015" where it slide inside the slip yoke so replacing the shaft should make the slip yoke section a little tighter fit.
I check the shaft for run out at the yoke collar by turning it b hand and also spin the driveshaft to check for vibration.
Thanks for watching.
Here is a link to a youtube video that shows an accelerometer module being used with an oscilloscope - • Vibration Analyzer for $20
I may purchase an accelerometer module to try with my two channel scope to see if it detects the vibration as a wave form.
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
