***SOLVED*** PixHawk PX4 VTOL Won't Arm
Автор: Flip on Tech
Загружено: 2016-07-28
Просмотров: 16636
Описание:
**SOLVED**
Updated QGroundControl to 3.0
Used Master firmware (at my own risk) instead of Stable version. This made available parameter settings not available in Stable version.
Pusher motor ESC cable needs to be plugged in AUX3 NOT AUX5 like the manual says.
Tx Transition switch needs to be set RC_MAP_TRANS_SW to 5 and remove the mapping from AUX1 Passthrough in QGC.
I'm a newbie with Pixhawk. My setup experience is with Tarot ZYX-M and Naza. I think I've followed every step in setting up this QuadPlane VTOL via QGroundControl UI. All required sensors and ESCs have been calibrated per instructions but it won't arm.
PM me for params file to look through.
The forward flight motor ESC just beeps, even though it's been calibrated directly from the Rx.
I've had it with and without the Airspeed sensor.
I use a Pix4 Airspeed v1.1 but it only recognizes the Airspeed sensor by setting SENS_DPRES_ANSC to 1000 and SENS_DPRES_OFF to 1.
I've also tried CBRK_AIRSPD_CHK to 16212
FW_ARSP_MODE doesn't show up in the Parameters Search.
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
![☀ FPV АВТО - автономный РОВЕР! Настройка MAVLINK через WiFi. [FPV RC Car | Ardurover]](https://imager.clipsaver.ru/GX0eJP3EMvM/max.jpg)
