wiring up your DIY motion simulator - arduino - IBT-2 - 3 DOF motion sim -

Описание: This video is demonstrates how to begin wiring up your DIY motion simulator - the electronic components - the aruduino uno, the IBT-2 motor controllers, the hall effect sensors.. I'm just showing you how I do this and what problems you may encounter.. It's a bit of a long video for me but if you really are interested in DIY motion simulators, like this 3DOF DIY motion simulator I showed how to make in the "compact" motion simulator series, then this video is for you.. please comment as I do attempt to cover even the most basic soldering, what to order, how to do it etc..

MUSIC
provided by You Tube content free music
-----
EMAIL ME at - [email protected]
____
Tie rod ends :
https://www.amazon.com/dp/B00ELO68CK?...

50:1 12volt motors just search Ebay for GEAR MOTOR 12 VOLT GREAT FOR SAWMILL/CRAB POT PULL/FEED/SIMULATOR 75-80RPM 50:1 (sold by PGSAW in Canada)

Hall Effect Potentiometers DIGI-Key and others PN 987-1392-ND
https://www.digikey.co.uk/en/products...

Arduino UNO R3 - amazon. I have also used the cheaper ELEGOO clone.
https://www.amazon.com/Arduino-A00006...

IBT-2 motor controllers up to 43amps (which is a lot!)
https://www.amazon.com/dp/B00WSN98DC?...

other motor controllers you could consider using are JRK12V12 or Sabertooth but I use IBT-2's

XSIMULATOR forum - Info specifically for arduino/IBT-2 for 1 to 3 Motors. You can use up to three motors per arduino. But you each motor needs it's own IBT-2 controller.
https://www.xsimulator.net/community/...

DMAX motion sim build posts on XSimulator
https://www.xsimulator.net/community/...