Arduino Uno R3 and IBT-2 Wiring A Motion Simulator

Описание: Hi sim racing junkies and fly boys. This is Pt 2 of the 3.5DOF motion simulator platform electronics tutorials. In this series of "how-to's". I'll take you through how to wire up your Arduino and IBT-2 motor controllers, along with how to wire and connect your PSU's and your motors. From there, we'll dabble with SMC3 utilities to bring our rig to life and then get into sim tools setup for our gaming experience. The full gamut to get you racing or flying, whatever your drug. If you are new to the channel I'd appreciate some love via a sub. Cheers for that. You have a lot to catch up on building your very own 3.5DOF motion simulator platform with the full detailed DIY series on my channel. Welcome aboard. Roll up your sleeves and make it happen peeps!

For my American friends needing to convert metric to imperial:
https://www.rapidtables.com/convert/l...

The Motors:
https://www.motiondynamics.com.au/wor...

The Power Supplies:
https://www.ebay.com.au/itm/373694487...

The 360 degree hall effect Potentiometers:
https://www.digikey.co.uk/en/products...

The Arduino Uno control board:

Genuine: https://www.jaycar.com.au/arduino-uno...

Clone:https://www.ebay.com.au/itm/265921195...

The IBT-2 43 amp Double H bridge motor controllers:
https://www.ebay.com.au/itm/134472854...

Visit my music page for some rocking guitar action:
https://kevinwindross.bandcamp.com/al...

Visit my current prog band Early Warning System:
https://earlywarningsystem.bandcamp.c...