ASL3 en Dell Wyse 3040 detallles de la configuracion Debian 12/11 unidad de arranque .Parte 2

Описание: Como instlar DEBIAN en DELL WYSE TESTED WITH DEBIAN 10/11/12



Flash debian-XX.XX.X-amd64-netinst.iso onto removable media and plug it into your Wyse 3040.
While booting the system, press F2 to enter the BIOS.
Change the boot device to your removable media and uncheck all other options (the default BIOS password is "Fireport").
bios setting####
To initially set up a 3040 requires a USB keyboard and a monitor/TV with a DisplayPort cable. Plug in the keyboard and DisplayPort cable, and plug in the Debian 12 USB drive. Power up the 3040 and when you see the Dell logo hit F2 to enter BIOS setup. Some 3040's may have a BIOS password which defaults to "Fireport". This can be cleared in the Security section or if some other password was set can be cleared with a button on the PCB.

Recommended BIOS settings:

System Configuration BIOS
→ UEFI Network Stack: Disabled
→ Integrated NIC: Enabled (NOT w/PXE)
→ USB Configuration: Enable all checkboxes
Secure Boot: Disabled
Power Management
→ AC Recovery: Last Power State
→ USB Wake Support: Disabled
→ Wake on LAN: Disabled
POST Behavior
→ Keyboard Errors: Disabled
→ Fastboot: Thorough
Virtualization Support: Disabled
Nothing should need to be changed on the boot order page or any other pages. Once you have confirmed the BIOS settings, save and exit, and then when you see the Dell logo hit F12 for the boot menu, then select the USB drive. The Debian installer menu will then appear.

The Debian net install image is intended to boot on a removable device and install Debian on an internal storage device (or on a separate removable USB drive / SD Card). This differs from the RPi "appliance" image which goes on an SD Card, into the RPi, and the install is done. The Debian install takes about 20 minutes to complete. The default options should be fine but if there is anything you are not sure about, do a web search from another computer and try to clarify any questions you have #########
Proceed with the standard installation.
After rebooting, boot into your Debian installation once again, but this time select "rescue mode". Follow the instructions until you see the option to "Force GRUB installation to the EFI removable media path". Click it, then click continue. Select "/dev/mmcblk0p2" in my case (you can check other mmcblk0pX options to see which one works for you), and then reboot.

URL DE PAGINA ASL PARA INSTALACION:Enesta paginas das scroll
hasta encontrarlo siguiente;Dell Wyse 3040 Micro PC

https://allscan.info/docs/diy-node.ph...