[BUILD] TBS Discovery - Time Lapse Build Log

Описание: How to build your TBS Discovery. This is a time lapse build log video of my FPV Discovery from Team Black Sheep.

Feel free to share, like, comment, subscribe.

Music: 'Perfect Tomorrow' by Mokhov (get it on BeatPick.com)

Here is the complete list of all parts for the setup: http://fpvlab.com/forums/showthread.p...

My setup includes the following parts:
• TBS Discovery top / bottom plate
• 750kV Motor & ESC Package
• Graupner 9x5" Props (2x CW, 2x CCW), most people use 10x5"
• DJI Naza Flight Control + GPS
• Scorpion battery velcro straps
• TBS 69 FPV Camera with splash-water proof
• 8x Servo Extensions for Receiver Mount
• 4x DJI Flamewheel Arms
• TBS CORE installed
• RF Tin Shield (optional, good if you use 433Mhz)
• Flamewheel VTx Mount
• Fatshark Dominator Video Glasses
• TBS Dominator Rx (5G8)
• TBS RC305 (5G8)
• TBS GREENHORN 5G8 25mW
• SpiroNET 5G8 RPSMA

Tips & Tricks
• For longer flight times, use low Kv motors and large propellers
• In DJI NAZA Assistant setup, start off using basic rate gain 150/155/120/100 and for attitude gain 125/125
• Center of Gravity (CG, CoG) is for balance, distributing the weight equally over each motor, bind two pieces of strings to create an X, this is the CG spot
• The center of thrust is 15 mm forward of the center of gravity, CoT balances the load equally on each of the four motors
• If it's too nose heavy it will bob up and down in forward flight, too tail heavy and it will get very pitchy/twitchy
• When "jello" effect (caused by high frequency vibrations) appears on HD footage, use a set of soft memory foam earplugs between the frame and the GoPro camera
• If horinzontal lines appear on the video stream, it is caused by the motor/rotor vibrations and apply a piece of gel, vibration reduction foam or earplugs to the video transmitter