SadoTech Starpoint Wireless System - Setup Installation

Описание: Setting up your Sadotech doorbell can be as simple as one, two, three.

Make sure your receivers are plugged in and in a safe area. The receiver has two buttons: One is a music control button and the other is a volume control button. Next up, make sure your transmitter or any of these products don't have these tabs. Please remove it. Let's pop this open, pull it out, and pop it back into place. Now we're ready to go.

First, let's adjust our volume level by pressing the volume control button and choose a desired volume. Let's do the same for the other receiver. Let's pair the products and also change the chime. By pressing the music control button, we can change the music. [Choose a chime].

Go into learning mode by pressing the two buttons at the same time. When you hear a sound, you press the button on the transmitter. Now you've paired this transmitter to this receiver. Let's do the same for this receiver here by going back into learning mode, pressing the button on the transmitter. Now you see that both receivers with this transmitter.

Follow the same steps for each of these three products, we should be able to do the same thing. Let's pick another music chime for this transmitter over here. [Choose a chime].

Go into learning mode now, press the transmitter and it has been paired with the receiver. Let's do the same for this. Go into learning mode, press the button and this has now been paired.

Next up, let's pair the LD sensor. By going into learning mode or changing the chime, you can set this up as well. By pulling apart the LD, it is now paired so let's put them back in together and do the same for this. Go into learning mode and pull the LD apart. Now the sensor is paired with these two receivers.

Finally, the LM sensor. Let's pick a chime. [Choose a chime]. Go into learning mode and then flip the switch. This has been set up. Let's turn the switch back off, and now pair it with this receiver. As you can see, this is turned off. Now, flip the switch. It's now paired and detects my hand. Let's turn it off and now learn how to reset or unpair these receivers with all four products.

By pressing and holding the music control button for 5 seconds, you'll be able to do that. Do the same for this. If you hear that noise, your products have been unpaired. As you can see, buttons no longer work. If I pull this apart, no longer works. Finally, turn this back on, no longer works.

That's how you configure your Starpoint products.