2011-2014 5.0L Coyote Mustang: How To Install Transmission, Clutch, Flywheel, & Slave Cylinder

Описание: In this video, Landan explains the procedure of how to install a manual transmission, clutch, flywheel, slave cylinder, and other related components into a Ford Mustang GT with a 5.0L Coyote engine and MT82 manual transmission.

Product Links
11-14 Mustang Transmission Parts: https://lmr.com/products/10-14-Mustan...

Watch
How To Remove Transmission, Clutch, Flywheel, & Slave Cylinder:    • 2011-2014 5.0L Coyote Mustang: How To Remo...  
How To Replace 5.0L Coyote Rear Main Seal:    • How To Replace 5.0L Coyote Rear Main Seal ...  
Coyote Crankshaft Sensor Ring - What is it & How To Install:    • 2011-2023 Mustang 5.0L Coyote Crankshaft S...  

Tool List
Transmission Fluid (per application)
Transmission Additive (per application)
Brake Fluid (per application)
Handheld Tuner or Ford IDS (for crank relearn procedure)
Jacks & Jack Stands or a Lift
Transmission Jack
Paint Pen
Shop or Microfiber Towels
Brake Clean
Wire Brushes
Anti-seize
Blue Thread Locking Compound
Clutch Disc Alignment Tool
Ball-peen Hammer Set
Punch Set
Flare Nut Wrench Set
1/2" Socket Set
3/8" Socket Set
3/8" Extensions
Wobble Adapters
T-30 Torx Bit or Socket
8mm Hex Socket
Long-reach Panel Removal Tool
Combination Wrench Set
Pick Set
Prybar Set
3/8" & 1/2" Torque Wrenches
7/8" O2 Sensor Tool (optional)
3/8" Wobble Socket Set (optional)

Chapters
00:00 - Intro & video explanation.
02:18 - Install the pilot bearing (optional).
02:43 - Open the clutch & categorize the contents.
02:55 - Install the locating dowels into the flywheel.
03:28 - Install the spacer plate onto the engine block.
03:56 - Install the flywheel.
05:22 - Install the clutch disc & pressure plate.
06:54 - Remove & install the slave cylinder.
07:51 - Fill the transmission with fluid (if you drained it) & prep for reinstall.
08:26 - Install the transmission.
10:07 - Install the transmission crossmember.
10:33 - Install the output shaft speed sensor & inspection plate.
11:00 - Install the starter & connect the clutch line.
11:34 - Install the head shields (if removed) & the driveshaft.
12:16 - Install the upstream oxygen sensors & install the mid-pipe.
13:28 - Install the k-member brace.
13:35 - Add fluid to the master cylinder or clutch reservoir (if applicable) & bleed the system.
14:08 - Install the engine bay components & reconnect the negative battery cable.
14:17 - Perform a crankshaft relearn.
14:35 - Final thoughts & outro.

#lmr #mustang #clutch

Use of this video is subject to the terms as set forth in our LMR Install Video Disclaimer | https://lmr.com/page/lmr-install-vide...