How to Suppress a (Mini) Draco feat. JMAC Facemount & PTG Crowning Tool

Описание: In this video I show you how to install a JMAC Customs 2C 14-1LH Facemount X37 - HUB (SKU: RRD-2C-14F-X37) onto your Romanian Mini Draco. In reality, I actually demonstrate a bunch of WRONG things (clearly highlighted and talked about) on how to do this. Namely: putting a crowning tool into a cheap Ryobi 18V drill gun and then over-filing material and having to correct it.

I go over the muzzle device, cover what facemounting is, discuss concentricity issues and how to address them, and show you how to use the 90-degree crowning tool and a small file to touch off material on your barrel.

IMPORTANT: JMAC warns against using the 2C X37 on barrels shorter than 10.5 inches...I fully accept any consequences...but I do not plan on mag-dumping double-tiddymags into trash with a binary.

I didn't cut too much, I did fast forward through the struggle sections so you can laugh at me at a rapid rate, but I think documenting my foolishness should serve as a good enough warning about what NOT to do. In reality, as long as you go slow and go by hand with the crowning tool you'll be fine to install the muzzle device onto your Draco (or other 14LH threaded AKM-pattern rifle). If you have some concentricity issues, they can mostly be corrected with filing towards the direction where you alignment rod is contacting your suppressor.

If you have a few hundredths (or a tenth or so) of non-concentricity, you'll need to have your barrel swapped, or just do not use a suppressor. Finally, I close with the cleanup process and final verification that I am still even.

Timestamps
Intro: 0:00
JMAC 2C 14LH Facemount X37 HUB: 0:55
Barrel Restriction Caveat (I Ignored It!): 1:56
About Facemounting: 02:56
Draco Recessed Crown: 05:08
PTG 90 Degree Crowning Tool: 05:33
Face off the barrel: 06:30
Crowning tool struggle montage: 07:03
Timeskip & filing talk: 09:17
Filing struggle montage: 12:00
Filing complete: 14:15
Cleanup & Rocksett Prep: 14:41
Outro: 17:09