Servo Test - 7 popular micro (9g) servos compared

Описание: About 5 months ago, I can't believe it was that long ago, I made a video comparing some popular micro servos. It was a pretty basic video, with one of the criticisms being that it wasn't overly scientific. You can check out that original video here    • Servo Comparison  .

So, this video properly tests the servo's strength and current draw at stall. Each servo is tested for all voltage levels that it is rated for, as well as a general base amp reading. The test rig consists of:
A 4S graphine LiPo, to supply more than enough power
A UBEC with 5, 6, and 7.4 volt output levels, with a maximum current rating of 6A
An L9R receiver, to command the servos
A voltage and amp display, to show what the servo is drawing
An electronic 10Kg travel scale, to measure the torque

Contents
00:00 Introduction
01:01 The test rig
04:19 MG90S
15:30 ES08A II
14:47 ES08MA II
23:51 ES08MD II
29:11 MG90D
32:53 ES3352
37:11 DS939HV
45:09 Results table

I tested the following servos:
Banggood "TowerPro" MG90S (4.8v & 6v)
EMAX ES08A II (4.8v & 6v)
EMAX ES08MA II (4.8v & 6v)
EMAX ES08MD II (4.8v & 6v)
Banggood "TowerPro" MG90D (4.8v & 6v)
EMAX ES3352 (4.8v & 6v)
Corona DS939HV (4.8v, 6v, & 7.4v)

If you found this video useful, please give it a thumbs up. For more content, please subscribe and click the bell icon. Please feel free to join in the fun at   / fixedwingrcrebels   too. Also, if you found my videos useful, and would like to leave me a little tip, you could always buy me a Coffee at https://www.mrd-rc.com/go/ko-fi/