DIY Guide: How to make your own BCR for MTH Protosound 1 & 2 Engines!

Описание: This video will go through how to make your very own BCR (Battery Component Replacement) for Protosound 1 & 2 engines. Normally these BCRs can cost $35 each, however by following this video you can make your very own BCR for $5!

Please leave comments and Questions below!

Parts:

9v BCR (For Protosound 1 and 2 5v engines):
9v Battery Connector: https://www.mouser.com/ProductDetail/...
2.7v 3.3f Supercapacitor (4 per BCR): https://www.mouser.com/ProductDetail/...
Zener Diode (4 per BCR): https://www.mouser.com/ProductDetail/...

5v BCR (For Protosound 2 3v engines):
JST connectors: https://amzn.to/4cGHypT
5v 2.5f Supercapacitor: https://www.mouser.com/ProductDetail/...

For both BCRs:
3/4 inch heat shrink tubing (to encapsulate the BCR): https://amzn.to/3VOBeX1
2mm heat shrink tubing (for the wires): https://amzn.to/3xjiQLN

Workshop tools used in this video:
Hakko Soldering Iron: https://amzn.to/3U7jLI5
Hakko Soldering tips: https://amzn.to/3vGTasc
Heat Shrink Hot Air Blower: https://amzn.to/3vGOoei
Wire strippers/Cutters: https://amzn.to/3xtlpex
Wire Cutter: https://amzn.to/3xvbrt5
Solder: https://amzn.to/3U9aiiD
Liquid Flux: https://amzn.to/3TP6JOn
Cotten Swabs: https://amzn.to/49s4FkV
Scott shop towel: https://amzn.to/49uRfF2

0:00 - Introduction
0:42 - 9V BCR for PS1 and PS2 5V Engines
6:48 - 5V BCR for PS2 3V Engines


DISCLAIMER:
This video is meant as guidance only. All information posted is merely for educational and informational purposes. Should you decide to act upon any information in this video, you do so at your own risk.