Dirt Cheap DIY ARB Twin Compressor Bracket | 1st Gen SEQUOIA |

Описание: Finally someone makes a one for us!
https://www.kamdesignstudios.com/comp...

In this video I make a set of engine bay mounting brackets out of 1/8" flat bar stock for an ARB twin compressor and show how I install everything from beginning to end.
I didn't want to have to pop my hood to air up so I ran the main out through the passenger front fender well. I have had zero tire interference/clearance issues so far and I play hard.

I have a cold air intake and I'm not sure how this would work with the factory airbox. You may still get some useful ideas from the the video.

Update 2/2/22
This idea never really failed in that the compressor never became loose or technically overheated. It was however getting too hot under the hood in my opinion. Bear in mind I'm talking mid-summer California desert temps combined with the heat from the engine bay. I found a new solution which mounts the ARB in the rear of my vehicle. I am working on editing that video and will upload it soon.
I'm leaving this video up to help spark creativity and new ideas.

Enter Treehouse10 for 10% off at www.skidrowoffroad.com

ARB Twin Compressor - https://amzn.to/3xBIWUR

If you choose to run your air through the fender well like I did you will need a few extra things. Here is what I used:

Viair 18" Stainless Steel Braided Leader Hose - https://amzn.to/2X6ZQ
Brass Bulkhead 1/4 Inch NPT - https://amzn.to/3ApNHTh
AstroAI ATG250 Digital Tire Inflator - https://amzn.to/3jIg60h
90 Degree 1/4 Inch NPT Elbow - https://amzn.to/3ApFoXr
T Plus 2 Pipe Thread Sealant - https://amzn.to/3jyHY6O