Vandy Vape Berserker MTL RDA full review.

Описание: Did you ever face a dilemma of wanting to taste a few new liquids in your tank but did not want to change a stock coil for each flavour or having to empty & clean the tank for each flavour tasting, I did!!!
The solution is obviously a RDA MTL tank so you only need to re-wick!!
And that was the only device that I was missing in my daily vaping gear, so after considering a few tanks, I decided to buy the Berserker MTL single coil RDA and I am happy to say I was not disappointed.
The flavour of my NET’s is excellent, easy to coil & wick, very good machinery, clever heat distribution mouthpiece design, airflow options with various airflow inserts to achieve the perfect MTL drew, easy to lift the top cap for dripping your liquid on the coil and perfect as a MTL sqounking tank.
If you will consider buying this tank may I point out a few facts that I learnt whiles using it.
Place the coil facing down so it is closer to the airflow hole in the plastic insert below.
Bed in the coil before you insert your preferred airflow insert as it can melt the plastic insert.
When dismantling the tank for the first time it will be tight, so lubricate the O rings with e-liquid or VG prior to putting all parts together, it will make life easier when you need to lift the top cap or turn the barrel for airflow adjusting.
When adding e-liquid if used as a dripper, it is recommended to squirt the e-liquid on either side of the deck on the cotton and not directly on the coil as you can experience a bit of gurgling as the airflow insert that is directly under the coil. (this problem is not relevant if used as a sqounker)
When wicking, to achieve the perfect length is by folding the cotton to reach the black O ring at the base of the deck.
Obviously keep the airflow slot of the barrel on the same side of the airflow slot of the insert.
The airflow option are wide but my preferred MTL method is to insert the biggest hole (2mm) plastic insert and adjust the airflow hole on the barrel to the 2nd (1.2mm) if you choose the biggest hole on the barrel (2mm) you can easily vape a restricted DTL.
Finally turn the cap clockwise to match your preferred air hole on the side of the barrel to the air hole on the insert and if you want to change the air flow settings always turn clockwise otherwise you will unscrew the tank from the mod.
I hope the above is helpful, I will appreciate your feedback in the comments below.