The RIFF 600/900 3D printer 3 - x and y axis

Описание: The RIFF is a large DIY printer that can be built without spending a fortune. You can build a 300x600 (RIFF 600) or 300x900 (RIFF 900) version of this.
Custom files can be found on Printables. https://www.printables.com/model/1291...
CAD model: https://github.com/itesdahl/RIFF

I encourage the use of second hand parts and will not provide any complete BOM listing specific new components.
----
Removing bearings from V wheels:    • DIY 3D printer - the complete build  
The length of the x-axis extrusion is 440mm
On my 600 build the 2020 extrusions for the bed assembly is 2 pcs 645mm. You have to check the bed mounts on your heat bed to determine if you need even longer extrusions in your build!
----
I am not using the best components available. I am using whatever I already have or can get hold of second hand. No AWD, canbus, large controller boards or special stepper motors in this build.

Some facts about the build:
• Filament used: Isanmate ASA (black), Filamentum ASA (RED) and SUNLU PETG (black)
• Build plate 300 x 600 or 300x900 (using 2 or 3 pcs 300x300 heat beds)
• 2020 and 2040 extrusions
• SKR 1.4 turbo and SKR Pico controllerboards
• Radxa Rock 3C SBC
• MGN 12H rails/carriage on Y and X
• 12mm rods and bearings on Z
• Cartesian (the belts are a bit too long for corexy)
• Klipper
• Dual Y steppermotors
• Sensorless homing on X and Y
• Dragonburner with Sherpa micro
• 2 x 360W 24V power supplies (3x 360W 24V in the 900 version)

Timestamps:
00:00 Trollolo
00:18 Parts for the bed
00:59 Y axis
07:30 X axis
13:38 Installing the belts
17:40 Mistake corrected

#largeprinter #3dprint #DIY