R34 GTT to GTR Conversion | Building Extended Inner Wheel Wells (Hardest Part!)

Описание: This is the hardest part of the R34 GTT to GTR rear-end conversion — building the extended inner wheel wells to properly fit the GTR quarter panels.

In this video, we tackle the challenge head-on and show you a simple way to extend the wheel well using an external fender flare. This video will also show techniques to fill the gaps left after fitting wider GTR quarter panels onto a GTT chassis. This is not a bolt-on job — and doing it wrong can lead to alignment issues, poor fitment, and potential rust problems down the line.

🔩 In This Video:

Explaining the gap between GTT and GTR quarter panel geometry

Custom fabrication of inner wheel arch extensions

Sealing and rust prevention

Tools, materials, and measurements we used

HZ Flare 3" (2 flares total)
https://www.umshop-store.com/product/...

MLV Seam Tape, 2" x 108'
https://www.amazon.com/dp/B0CHWV8QQP?...

3M Cavity Wax 08852
https://www.amazon.com/dp/B0741FHDPF?...

3M Cavity Wax Plus Applicator Wand Kit 08851

Epoxy Gun Dual Component Caulking Gun
https://www.amazon.com/dp/B0D1KB7HBY?...

3M Manual Cartridge Applicator, 08571
https://www.amazon.com/dp/B002QWYG1O?...

3M Rigid Pillar Foam 08458

This video is your blueprint for the most technical part of the conversion. No guesswork — just real amateur fabrication and trying my best to figure it out through real problem solving, and a semi clean result. I won't lie, it isn't pretty, but it will work!

💡 Tip: Take your time here. This step will make or break the quality of your conversion.

🛠️ Watch the full R34 GTT to GTR Build Series:    • R34 GTT to GTR Rear Quarter Panel Removal ...  

📷 Follow the build daily: V_Vs_G
📩 Questions? Drop them in the comments — we’re here to help!

#R34 #SkylineGTTtoGTR #InnerWheelWellBuild #R34GTRConversion #CustomFabrication #JDM #SkylineBuild #GTRLook