PSA: The Joy of 3D Printing - Artillery Sidewinder X2
Автор: Hau3D
Загружено: 2023-03-05
Просмотров: 2921
Описание:
The print starts well. However, at some point it comes off...
Fresh level set and print bed cleaned. I have tried other models that print "larger" but always the same result....
Then I found a post on Reddit saying, that the auto level info is stored on the thumb drive of the Artillery Sidewinder X2. First I found that hard to believe as it says "Save to EEPROM". In the end i tried it, because at some point I removed the thumb drive as I'm using OctoPrint. Fresh level set, print bed cleaned and everything works again.
Printing was done with PLA.
Nozzel on 210°C
The print bed is at 60°C
First layer is printed with 0.3mm.
#shorts #3dprinting #fails
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
