HOW TO SET HYOSUNG 250CC AND 125CC CAMSHAFT TIMMING IN 5 MIN!!!

Описание: CYLINDER CLASSIFICATION
The engine of Hyosung 250cc and 125 cc composed of the two cylinder, is classified into the front cylinder and rear cylinder as basis of the motorcycle ahead.
Today I will be doing tutorial on how to do CAM SHAFT TIMMING IN HYOSUNG Comet 250, comet 125, GTR 250 , GT 250 ENGINE.
DO CAMSHAFT ASSEMBLY IN THIS CASE WE HAVE four cam shafts, 2 for intake and 2 for exhaust.
Make sure you have distinguished the EX mark for exhaust camshaft with the IN mark for the intake camshaft.
• flywheel should be marked F for the front cylinder and R for rear cylinder. Leave it there.
• Align the index mark on the magneto rotor with the index mark on the magneto cover as turn the crankshaft counter-clockwise.
FIRST. THE FRONT CYLINDER CAM SHAFT
With pull up the camshaft drive chain, align the F mark of magneto rotor into the punching mark of magneto cover to turn the crankshaft.(Front cylinder)

STEP 1: The IN and EX cam always has a “DASH” mark also called notch mark on the end of the of spindle — that DASH or notch____ is always 100% straight horizontal line with the EDGE of the engine cover
STEP 2: For the exhaust camshaft sprocket has mark number 2. THIS NUMBER 2 must be always facing 100% accurately upwards that is (Straight vertical) .
Then the notch mark of exhaust camshaft should be toward the outside. On left side.
STEP 3: For the Intake cam sprocket number 3 MARK faces 90% upwards 10% tilted to the RIGHT. whichever side you look at, the number 3 must be a little lean towards RIGHT. instead of a straight line like for exhaust Cam. Then the notch mark of intake camshaft should be toward the outside. On the right side.
STEP 4 : and the last step count the 16 chain roller pin from the mark 3 arrow of intake sprocket to the mark 2 arrow of exhaust sprocket.

THE REAR FRONT CYLINDER CAM SHAFT AND DO THE TIMMING
When adjusting the rear cylinder, align the R mark of magneto rotor into turn counter-clock-
wise the position of front cylinder. Align the R mark of magneto rotor into the punching mark of magneto cover to turn the crankshaft.

STEP 1: make sure you have the in cam and ex cam at the right place .The IN and EX cam always has a “DASH” mark also called notch mark on the end of the of spindle that DASH or notch__is always 100% straight horizontal line with the EDGE of the engine cover. Remember that always .
STEP 2: At that time, the mark 2 arrow of exhaust camshaft sprocket should be in a vertical position to the plane of cylinder head when exhaust camshaft sprocket was
geared into camchain. (Straight vertical) .
Then the notch mark of exhaust camshaft should be toward the outside. On left side.
STEP 3: For the Intake cam sprocket the mark 3 arrow of intake camshaft sprocket should be in a vertical position to the plane of cylinder head when the intake camshaft sprocket was geared into the cam chain. Then the notch mark of intake camshaft should be toward the outside facing the right side.
STEP 4 : and the last step count the 16 chain roller pin from the mark 3 arrow of intake sprocket to the mark 2 arrow of exhaust sprocket.

Just a CAUTION

The cam chain is installed to the all of three sprockets. Be sure to lie the crankshaft until the four holder and cam chain tension adjuster are installed completely.
now After successful timing the front and the rear cam shafts turn the crankshaft 10 times manually. At this time you will listen if there is any noise coming from the engine just a precaution test.