How to Replace the Impeller on Flygt N 3085 & N 3102 Pumps with Adaptive N® Impeller

Описание: This is an informational video on how to replace the impeller on a Flygt N 3085 or N 3102 pump featuring an Adaptive N impeller. This video is intended as a general reference for technical personnel tasked with maintaining pump performance and ensuring the replacement process is done safely and effectively. This video is NOT intended to serve as a step-by-step, fail-safe checklist. Projects vary and may require additional steps provided for in the Manual not included in this video.

Flygt N-pumps take on the toughest applications and get the job done. With the patented Adaptive N self-cleaning technology you can ensure the highest total efficiency in your small wastewater pumps.


To learn more about Adaptive N technology and the pumps in this video:

https://www.xylem.com/en-us/products-...

https://www.xylem.com/en-us/products-...


Contact us here: https://www.xylem.com/en-us/brands/fl...

Subscribe to our channel for more insights on how our innovative solutions are transforming water and wastewater management.

Disclaimer Warning:

Carefully review the product specific Installation, Operation and Maintenance manual (“Manual”) before tampering with the product in any way.

All user safety rules and instructions contained in the Manual, as well as any other applicable safety rules, must be observed.

This video is provided as general reference only, as a complement to the Manual, and cannot be relied upon as a substitute for professional advice.

Failure to follow all instructions in the Manual may void the manufacturer's warranty.

If there is a question or any uncertainty regarding the intended use or maintenance of the equipment, contact a Xylem representative before proceeding.

Xylem cannot be held responsible for any actions or inactions undertaken as a result hereof.

00:00-00:10 Introduction

00:10-00:25 Remove the Impeller Plug

00:25-00:48 Loosen the Impeller Screw

00:48-01:13 Lift and Loosen the Pump Housing Screws

01:13-01:46 Lift off the Drive Unit and Set it in a Horizontal Position

01:46-01:58 Pull out the Impeller

01:58-02:14 Remove the Impeller Screw, Washer and Conical Sleeve

02:14-02:25 Clean off and Grease the Shaft

02:25-02:40 Fit Conical sleeve, Washer and Impeller Screw

02:40-02:53 Fit the Impeller

02:53-03:03 Tighten the Impeller Screw

03:03-03:33 Fit the Pump Housing

03:33-04:25 Check Impeller

04:25-05:04 Fit Lubricated Impeller Plug

#Flygt #ServiceVideos