How to Make a SHORT Battery Cable for DJI FPV Goggles - DIY XT60 + USB-C Power Cord

Описание: Check out https://www.pcbway.com/ for custom printed circuit boards and rapid prototyping services!
Get rid of the dangly USB-C power cable that comes with the DJI FPV goggles and make a shortened cable with a XT-60 connector so you can power it from a LiPo flight battery! I'll show you how I did it using the original cable and a XT-60 connector. As long as you can solder, it's a pretty simple job! 👌This is easily one of the best and cheapest upgrades you can do for your goggles (mine are the V2, but that doesn't really matter).

🧠 FREE RESOURCES, 3D Printable Designs, and more for FPV Drones, RC Aircraft & 3D Printing at http://rcwithadam.com/

Want to support RCwithAdam? ↴
KO-FI: https://ko-fi.com/rcwithadam
OR
PATREON:   / rcwithadam  
Thanks!

00:00 hello!
00:50 Why
1:55 First cut
3:16 Checking plug polarity
4:15 Cutting, Tinning, soldering
6:41 Important note
7:03 Final checks + finishing touches
-------
Mandatory Affiliate Disclaimer:
Any links in this description may be affiliate links, which means I make a very small commission (at no additional cost to you) when you make a purchase through that link.
*DISCLAIMER: Remember to always use caution and your best judgement when building and flying RC aircraft, and when working with 3D printers, electronics, or electrical devices. Be mindful of the laws, regulations, and best practices for your particular location. Be a good neighbor, and HAVE FUN!*
-----------
About RCwithAdam: Adam's goal is to HELP YOU build your skills and eliminate frustration and confusion through creative, educational, and encouraging videos featuring Radio Control airplanes, FPV drones, electronics, and 3D printing!
#RCwithAdam