BECOME A HAIRCUTTER, Unit 13, 2-Dimension Pixie Haircut

Описание: Welcome to Unit 13, 2-Dimensions Pixiecut
 
00.34
We see a graduated length arrangement. This type of graduation, which increases towards the top of the head, is also called rounded graduation. The increasing lift-off angle in the swirl area takes the heaviness away from the top coat, creating a layered look. The inner area is uniformly graduated.
 
00.42
We first divide the inner area with a horizontal section that runs around the highest point of the head. The front contour is also left free.
 
01.08
We start this haircut with a vertical section on the A axis in the center of the neck.
 
01.13
Comb the hair into a high lift-off angle and position your fingers at a high angle as well.
 
01.42
Work from the center outward with vertical sections and mobile, two-dimensional finger position. So move with outward to the width, but not around the curve of the head to the depth. Take the last cut section as the guide length, combaway the remaining hair so that it does not interfere.
 
06.22
Work with the same workflow on the other side. Make surethat the fingertips continue to point upwards and comb themfrom the outside to the inside. This will ensure a symmetricallength throughout the nape of the neck.
 
08.38
Define the contour line by combing the hair into its natural fall and working in a slightly convex line.
 
09.18
Now set a new guide length on the B axis in the middle of the ear. First work mobile two dimensional towards the nape of the neck. Keep the lift-off angle and finger position from the back of the head.
 
12.40
When you have finished the technique in the direction of the nape of the neck, i.e. no more hair lengths reach the cutting line, process the front profile area in the same way.
 
14.10
Then define the contour line in the natural fall.
 
14.40
Proceed in the same way on the opposite side.
 
19.08
Now work on the forehead motif. Comb the hair verticallyupwards. Position your fingers horizontally and cut themaccordingly.
 
19.50
Divide the vortex area on the B axis, comb the hair backwards, make a first division on the A axis vertically. Pick up the section, comb the hair horizontally and position your fingers vertically. Now work from the inside out. Divide two-dimensionally vertically, they continue to work mobile two-dimensional.
 
22.00
Once they have finished the first side, they move on to the second. Take over the workflow.
 
23.22
Now divide the upper head on the A axis. From this subdivision, make vertical divisions. Now machine one sidefirst, then the other.
 
23.53
Comb the hair at a 90 degree angle to the rounding of the head. Position your fingers lengthwise from the outer area towards the A axis. Take the guide length from the swirl area and cut it.
 
24.33
Transfer the length towards the front contour mobile two-dimensional.
 
26.37
Proceed Sue in the same way on the second side.
 
29.00
Now connect both sections at the top of the head by slightlyshortening the longest hairs along the A axis with a uniform step.
 
30.45
Blow dry the hair with a tunnel vent brush.
 
32.50
Then texturize the ends of the hair with a coarse texturizingscissors. Work narrow sections, comb them at a 90 degreeangle from the head rounding and work them until you achieve the desired result.
 
37.40
Here you can see the finished result.