How to Install a Pontoon Boat Cover | National Covers

Описание: Learn how to install a pontoon boat cover the right way!

Learn More & Shop at: www.NationalBoatCovers.com

----------Transcript Below----------
National Covers is America’s #1 choice for Boat covers and Bimini tops. For over 25 years National Covers has offered superior products at competitive prices – all backed by outstanding customer service.

Our marine grade boat covers feature sewn in shock cord for a snug fit and include 12 heavy duty cover straps, as well as stuff sack for storage when not in use.

Before installing the cover on your boat, examine it for any sharp points that may potentially puncture the fabric.

Cover these with an extra cloth or foam pad if necessary.
Locate the bow end of your cover with the sewn in label that says front.

Place the bow end of the rolled cover on or near the bow of your boat and unroll towards the stern or back, positioning it down the center of the boat as you unroll.

Slip the front of the cover over the bow and pull the cover open to the sides as you work toward the back of the boat.

Adjust the cover fit by pulling cover tight to eliminate sagging areas.

On a properly fit cover, the sides should come down past the rub rail of your boat and be above the trailer.

Use the provided XT straps to tie-down your cover for a snug and tight fit. Be sure to use all of the straps provided if you are trailering the boat.

Run the XT straps through the sewn in loops that are located at two feet intervals along the cover seam. You don’t need to use all the loops on the cover, but should use all the straps provided.

Fasten XT straps along the trailer frame & tighten straps for a secure fit.

National Covers - America's trusted cover source for over 25 years.