Programming N9600A TNC Firmware with MPLAB X IPE 5.30

Описание: This video shows how to use MPLAB X IPE to program a firmware .hex file to an N9600A TNC.



In the setup, a PICKit 3 is connected by USB to a Widnows 10 PC. The PICKit is also attached to the ICSP header on an N9600A2 TNC. Both mode selection dip switches must be in the low position (9600 AX25). The TNC must be powered up.


Select the Device (dsPIC33EP256GP502)
Connect to the programmer (confirmation text appears in Output window)
Select the Hex file
Press "Program" and wait for "Program/Verify Complete" in the Output window