Picatinny Rail Mount **5 inch barrel version** - Function Test - Phoenix Arms HP22A HP25
Автор: ZD Craft Co.
Загружено: 2023-05-20
Просмотров: 449
Описание:
In this video I will do a function test of my newest product, a 3D printed Picatinny Rail Mount for the 5 inch barrel. This product will allow you to use larger accessories such as high power scopes, sights, and lights to extend the reach of your Phoenix Arms pistol.
This version for 5 inch barrel can be purchased here:
https://www.ebay.com/itm/277291986873
The smaller rail for the 3 and 5 inch barrel can be purchased here:
https://www.ebay.com/itm/277023358768
The scope used in the video can be purchased here:
https://www.amazon.com/dp/B073QM8FP9
The grips can be purchased here:
https://www.ebay.com/itm/277409888937
https://www.ebay.com/itm/277409886414
The product is printed in PETG on a custom built machine in Bellingham, WA. Each package includes (1) rail mount with hardware, and (1) 5/64" hex key.
Installation Instructions:
1.) Remove screws with hex key and set aside.
2.) Place one half of the rail mount on top of the barrel ridge keeping end flush with the breech.
3.) Position the other half of the rail mount on the barrel ridge and pinch and hold with your fingers.
4.) Reinstall the screws.
5.) Tighten the screws until snug. The screw ends should be about flush to the nuts. Be very careful to not over-tighten the screws.
6.) Install your optic or accessory on the rail mount and you are ready to do some plinking!
*Attention*
Upon installation, buyer assumes responsibility for any risks associated with the use of these aftermarket firearm parts. Limit rapid fire as this could heat the barrel above 160F and weaken the rail mount. Returns will not be accepted if damage results from over-tightening of the screws.
Thank you for your time. Always follow safe firearm protocols.
Other accessories for the Ruger LCP 380 can be purchased here:
https://www.ebay.com/itm/276969341191
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке: