My Prusa MK4S' COLD SPOTS were bad, so I fixed them! Now the MK4S has the most even heat

Описание: Fixing the cold spots was easier than I expected, and it should work for the Core One also.
Help support this channel!   / needitmakeit  

3M Venture Foil - Brand name (121C) - https://amzn.to/4oGppND
APT Foil - A little higher temp (149C) - https://amzn.to/44TYpTA
Kapton Tape 2" - https://amzn.to/4rHuGHq
MK4S Bed Template & Standoffs - https://makerworld.com/en/models/2082...

A short list to help support this channel, thank you so much for your help!

Bambu H2C - https://tidd.ly/3K3sSY9 (If you print with color, this is the way)
Bambu P2S - https://tidd.ly/3ISZkfq (Best value)
Bambu H2S - https://tidd.ly/4olSRbL (Most options for money)
Bambu H2D - https://tidd.ly/4q9RsHk (A dual color beast)
Bambu Filament Shown in Videos - https://tidd.ly/4hn6TYI
Rode Wireless ME mic (Saved me about 4+ hours/vid) - https://amzn.to/3vcMKAr
Mag clip (Super handy, but a little pricy) - https://amzn.to/3NBFvZe

I still have an attachment to the bed slingers even though they are slower and have more mass to move in the Y direction, and the Prusa MK4S is a really nice printer, it performs so well even when I put in the filament from their Arch Nemesis. But after performing a thermal test on the bed, I was surprised to find out that it doesn't have an even heating, not even close and it also has a really low max temp compared to the set value. This wasn't something that I could live with and I think a lot of other people out there would want a fix too. I used the thermal camera and looked at everything to find out why we were losing so much heat in some areas and with a little detective work I think we figured it out. I tried a few fixes, but there ended up being two big ones as you'll see from the video.

#Bambu
#prusa
#H2C