Chip & Flake Floor Sealer, Achieve Smoother Top Coats For Less $$$ - Acrylic Coating 230 W

Описание: Achieve smoother top coats and save money on your polyaspartic garage floor coating finish. Instead of applying two polyaspartic top coats for a smoother finish, apply one coat of this acrylic coating and sealer after scraping your chips. Let the acrylic air dry for 1-2 hours until dry to touch (depending on temperature and humidity) and then top coat with one coat of polyaspartic.

In winter months in Phoenix, AZ, installers will often use fans and blow dryers spread across the perimeter of the floor to speed up the drying time.

We came out with Acrylic Coating 230 W to meet the demand in the industry for a lower cost smoother top coat option. Acrylic Coating 230 W achieves this by saturating and sealing the chip layer, allowing your polyaspartic top coat to truly sit on top of the chips. Traditionally, the first coat of polyaspartic would saturate the chip layer resulting in the need for a second top coat if you desire a smooth finish.

PRODUCT DESCRIPTION AND USE
Acrylic Coating 230 W is a self-crosslinking, acrylic emulsion, waterborne acrylic coating and sealer used in a variety of decorative concrete applications. The latex can be used in clear formulations for “wet look” concrete coatings or pigmented formulations for garage floor coatings. It provides excellent chemical, hot tire pick-up, and weathering resistance including excellent UV and non-yellowing characteristics. 230 W also has good adhesion, dirt pick-up and blush resistance. It is available as a clear coating and sealer, for those seeking color we have waterborne pigment packs that can be used to tint the acrylic to any desired color. This material dries very quickly and is relatively high solids for a single component acrylic emulsion.

Smoother Top Coats Without The Extra Cost.
This product was specifically engineered to fill in and even out the high and low points in a full broadcast chip and flake floor system to produce a smoother top coat. To be applied after scraping and recovering the excess chips and flakes, and will help produce a much smoother overall finish when being top coated with polyaspartic. Specifically designed to be coated over by our Polyaspartic 485S, our 85% solids polyaspartic resin. You may also top coat over 230 W with solventborne polyurethane. When you want a smooth top coat, Acrylic Coating 230 W, will enable you to meet this need without requiring a 2nd, more expensive, top coat of polyaspartic.


For more information contact Slide-Lok.

1.800.835.1759 | [email protected] | www.slide-lok.com