DIY: BMW E39 Ignition Switch Replacement

Описание: Video tutorial on how to replace the ignition switch on a BMW E39. The same switch is found on others models as well, as for the replacement portion, it may vary. A faulty switch can cause multiple issues such as triggering dash fault lights, radio malfunctions, exterior or interior light malfunctions, gauge malfunctions, battery drain, intermediate starting, etc. For my vehicle, I was experiencing a battery drain as well as intermediate starting. This particular tutorial was done on a 1997 BMW 540i.

Website: http://4diyers.com
Facebook:   / 4diyers  
Google Plus: https://plus.google.com/+4DIYers
Twitter:   / 4diyers  
Instagram:   / 4diyers  
Tumblr:   / 4diyers  
Pintrest:   / 4diyers  

Tools/Supplies Needed:
-phillips screwdriver
-small standard/flat screwdriver
-standard/flat screwdriver
-13mm socket and ratchet or wrench
-T30 torx bit with a 1/4" drive ratchet

Procedure:
-start by removing the top and bottom plastic phillips screws holding in the clips which hold the steering column caps in place
-once removed, slowly work at removing the steering column caps
-tilt steering wheel when necessary
-after the steering column caps have been separated, unclip the leather covers from the rear both on the top and bottom
-tilt steering wheel when necessary
-next unclip the wiring harnesses from their retaining locations
-remove the two T30 torx bolts from the side and from the bottom of the steering column holding in the plastic retaining bracket
-tilt steering wheel when necessary
-disconnect the negative battery terminal using a 13mm socket and ratchet or wrench
-using a standard screwdriver, unclip the ignition switch wiring harness
-now remove the two standard/flat grub screws holding in the ignition switch
-if there is red paint over the grub screws, simply clean it off with a standard screwdriver
-remove the ignition switch
-when reinstalling the new ignition switch, ensure that the center rotation portion matches either the same orientation of the old ignition switch or the metal shaft
-reinstallation of all parts in reverse of removal

Thank you to all those who watch my videos and support my content. Don't forget to subscribe to my channel for future tutorial videos and like my video if you found it helpful. New videos are always being uploaded every week!

© 4DIYers 2013
All Rights Reserved
No part of this video or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author.