How to Drain LELIT Victoria

Описание: PL91T (LELIT Victoria) Draining Instructions
1) Preparation:
Remove the portafilter and drip tray.
Take out the water tank (if applicable).
Turn off and unplug the machine.

2) Access the Boiler:
Remove the two T20 Torx screws securing the top panel.
Lift the panel using the small tab inside.

3) Disconnect Tubing:
Identify the two push-to-connect tubes inside.
Pinch the collar and pull out the tubing to allow air in and water out.

4) Drain the Boiler:
Place a bowl underneath or position over a sink.
Flip the machine upside down to let gravity drain the water.

5) Reassemble the Machine:
Reconnect both push-to-connect tubes.
Reinstall the top panel, ensuring the gasket is secure.
Reinsert and tighten the two T20 Torx screws.

6) Final Check:
Ensure all parts are securely in place.
Machine is now drained and ready for storage or maintenance.

7) If you are draining for long term storage, I would recommend factory resetting your machine as well so when you turn it back on the machine will run through saturating it self.
To factory reset: Turn the machine off, hold the +, turn the machine on. It will say "Preset Done". Turn the machine off, then turn it on again, it will run through the cycle of pouring water from the group head for about 20 seconds.