FredoCorner - Tutorial - Offset Mode
Автор: Fredosix
Загружено: 2018-10-14
Просмотров: 1102
Описание:
As of FredoCorner 1.2, two offset modes are supported
1) OFFSET: offset is measured on border faces, perpendicularly. This gives a global uniform rounding of shapes
2) RADIUS: offset is computed based on a circle of specified radius which is tangent to the border faces. The offset is therefore dependent on the angle at each individual edges. If the angle is lower than 90 degrees, the rounding will appear larger in width, or smaller if the angle is greater than 90 degrees. Visually, the rounding of a shape may end up with non uniform rounding.
Main page of FredoCorner is on Skecthucation at
https://sketchucation.com/plugin/2120...
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
