New! 5 Minute Drying Mosaic Grout, How to Grout or Plaster your Turkish Mosaic Lamp? DIY Kit

Описание: How do you Grout or Plaster your Turkish Mosaic Lamp? - Sultans Treasure DIY Turkish Mosaic Lamp Kit
Our New 5 min Setting plaster/grout is quick and easy to use!
Follow this easy steps for creating a master piece!

This is a new grout different to our submersion technique - if you are unsure which grout you have refer to your instructions inside your DIY kit or contact us at [email protected]

MIX THE GROUT STEP
1 Add your Grout to the cup or a recycled container. Add tablespoons of water slowly whilst mixing until you reach a smooth paste similar to the consistency to soft pancake batter; free of lumps. Dont add too much water at once!
APPLY THE GROUT STEP 2
Don rubber gloves and work your way slowly around the glass methodically adding grout gently to the surface. Do not rub too hard otherwise the beads might dislodge. Do not be too concerned if one or two of the beads fall out, just gently fill the holes. The whole glass will be covered in grout including the surfaces of the glass and beads. The glass should be covered and all cracks and holes full but not excessively weighed down with excess grout. Once Grout has been spread over the surface leave for 3 to 5 minutes to firm.
CLEANING THE SURFACE STEP 3
Prepare one bucket or icecream container of water for rinsing. After the grout has been let sit for a maximum of 5 minutes; its time to clean the surface.
Wet the sponge so that it is not heavy with water but very damp. Sponge the excess grout off the surface leaving the tops of the mosaic and beads exposed.
Use the bucket of water to clean your sponge and return to cleaning the surface of the mosaic. Keep going wetting the sponge – wiping – cleaning the sponge until the grout is still in-between the beads and cut glass but exposing the shiny tops of beads and mosaic cut glass! Dry it off and polish it with and old cloth.
DRYING TIME
Depending on the weather it is best to leave for a day or 2. Once it is all dry and clean you can then attach it to your lamp base or if a tealight use it to make your table glow!