Bonding Primed Titanium to LDPE

Описание: Need to Bond it? RELTEKiT (TM).

Demo on bonding LDPE and Titanium that was previously primed with one of RELTEK's Primers.

*Previously primed with RELTEK primer/adhesion promoter C-52 (in this example).
[For the demo on Applying RELTEK’s Primers/Adhesion Promoters, see separate video:    • Applying RELTEK Primers/Adhesion Promoters  ]
*Will later do Tensile testing on this sample.

**DISCLAIMER:
Other product names, logos, and brands are property of their respective owners.
Our use of them is for example or reference, and is not intended as endorsement or affiliation.

ITEMS USED/NEEDED:
Primed Substrate (Titanium pucks primed with RELTEK C-52 in this example)
Polyethylene/Substrate (Borealis LE6006 in this example formed into 1x1 squares)
Hot Plate or similar heating surface
Heat Lamp or other additional heating if needed
Thermal coupling with temperature reading
Protective Gloves
Cotton-tip stick (ex. “Q-Tip”)

**IMPORTANT: **
PRIOR to bonding, first clean/prime/prepare the substrates that will be bonded.
See our separate video on Applying RELTEK Primers (   • Applying RELTEK Primers/Adhesion Promoters  ).

STEPS:
1. Put first Puck onto Hot Plate.
2. Put LDPE on Puck to melt.
3. Bring melt temperature of polymer to at least 210-220+ degrees centigrade/~400 degrees Farenheit (depending on polymer).
4. Add additional heat if needed, such as a Heat Lamp.
5. Once at melting point (~160 degrees centigrade), add 2nd puck on top.
6. Aim for 210-220 degrees centigrade. Lower heat lamp closer down, so both pucks get to heat range above 200 degrees centigrade, and 215-220 degrees centigrade for interface.
7. Clean up sides as melting.
8. Turn off heat- Leave pucks on plate, let cool to relax and avoid delamination from thermal shrinkage
9. Cut off excess melted sides.
10. If out of alignment, reheat enough to move pucks to alignment and re-cool and re-trim.

In 5-6 days later the tensile testing can occur, allowing full adhesion and migration.

_RELATED VIDEOS_
Demonstration on applying a primer from RELTEK to the Titanium pucks:    • Applying RELTEK Primers/Adhesion Promoters  

_QUESTIONS?_
If you ever have technical questions about choosing or using our products, don't hesitate to contact us (RELTEK, LLC)!
Email: [email protected]),
Phone: 1-707-284-8808;
-- Toll Free: 1-877-RELTEKiT [1-877-735-8354]
Website: reltekllc.com

_ABOUT RELTEK, LLC_
RELTEK, LLC is a high-performance adhesives, sealants, and coatings manufacturer that "Solves the Insolvable With Extraordinary Customer Service, and Sticks to You Forever" (TM).

COPYRIGHT RELTEK, LLC 2018-2019
Product lines such as BONDiT (TM) are RELTEK, LLC's own products and Intellectual Property.
---