Fitting an adjustable rear Panhard arm and Rear Sway Bar Extension plates on a Landcruiser 80 series

Описание: While this COVID-19 is happening it gives me a chance to get a few more things done to my 4WD I call "Caspa" as in the white ghost that goes everywhere.

In this video, I'm showing what I went through to change over the rear Panhard arm with a new adjustable one and a new correct set of rear sway bar extension plates for my Toyota Landcruiser 1992 model with a 3" lift, seeing these had not been done in the past by the previous owner when fitting the lift to make it a correct lift kit. All that was done was a set of Heavy Duty springs and OME shocks fitted to give him the 3" lift.

All corrective work since I purchased the vehicle in December 2018 is carried out by me and this lot of stuff was done on 15 April 2020.

This is another video in the series of updates on "Caspa" My 80 series 1992 Toyota Landcruiser wagon that I purchased in 2018. I am slowly doing up ready to start using as a daily driver and also for getting away camping and visiting more of Australia with.

Follow my journey as I get it ready to use, most of the mechanical work I try to do myself saving money but there are just some jobs I cannot do due to lack of equipment and some tools or the appropriate mechanical knowledge and experience etc..

I am based in the inner western suburbs of Melbourne Victoria Australia.

Thanks for watching.
Tim.

If you enjoyed this video please like, comment and subscribe to see more videos as I make and upload them.
Please bear in mind that I am still quite a novice at making these videos and usually forget to get the phone out and set it up to make the videos until after I have finished or partway through doing what I am doing and think about making it into a video.

My videos are made on my Samsung S6 & S8 mobile phones, usually with the S6 on my DIY made stand.
My videos are edited with OpenShot Video Editor program which is Opensource (free to everyone) https://www.openshot.org/download/
My Samsung S6 is on a DIY stand that I made. (A video of the stand and how I made it will be produced and uploaded shortly)