Starsplas | Laminating Machine for SPC Flooring Production SOP

Описание: StarsPlas is a full-service company that works to strenngthen your project by Technical supporting, know-how Trainning, and share.

Laminating Machine for SPC Flooring Production in US
Step 1: Heat Up
Anilox roller heating, controlled by die temperature machine, 165°Hold it open for 2 seconds
Scraper heating, touch screen control, press green on the left, temperature set in electric cabinet (130°)Heat up the glue, turn on the side power, 165°,The rubber drum and hose are heated synchronously.All temperatures reach 1 hour

The Step 2: Adjust the total speed to 20;Click manual control.Start anilox rollerLet the glue melt (more than 10 minutes)The preparation work has been completed before starting up, which takes one and a half hours.Starting steps:PLC control:Switch to automatic mode, only in automatic mode can work;Automatic start of cutting (transverse cutting)Remove the glue tray and lower the roller to 3.8-3.9mmPress the start buttonIf you cannot start at this time, you need to check the alarm content.Material shortage does not affect the start, but can be ignored.If the emergency stop button is pressed, the device needs to be restarted:The die temperature machine needs to be restarted (long press 2 seconds), the scraper needs to be restarted, the cutting needs to be restarted, switch back to automatic mode.Use two floors to do film test, test after passing continuous production.During the production process, special personnel are responsible for checking the consumption of membrane and glue.Membrane changing steps () :When the membrane is consumed to 1~2cm, press the button of "apply the membrane to pause";Release or deflate gas;Pull out the remaining film and fit the new film;Put the new coil back and open the expansion shaft.Click "reset film speed", and then press "pause film"Add glue steps:When insufficient glue is found, switch to manual, press the green start button;The middle gray button can adjust the amount of glue;Press the stop button when you have enough glue.The maximum amount of glue should not exceed the blade aluminum plate.Shutdown steps after work:Click the stop button;Turn off all heating units; Adjust the anilox roller to 40mm, put it into the rubber plate and turn off the main power supply.

How to order Laminating Machin:
Gmail: [email protected]
Social: @Starsplas
YouTube:    / @starsplas-spc  
Facebook:   / starsplascom  
Instagram:   / starsplas  
Twitter:   / starsplas  
LinkedIn:   / star.  .

#Laminating #machine #StarsPlas #SPC #Flooring #Production #USA #GA #Altlanta #Americanfactory