[Quick Demo] Custom Necktie Embroidery With Gold Thread

Описание: Today, we are adding a small accent on the tip of a tie using gold embroidery thread by Madeira.

Thanks for watching my video. Hopefully, this was either helpful or entertaining to somebody out there!

🔔 Subscribe for more decorating videos like this ➡️ https://bit.ly/3lPkpbk

🧵 Embroidery Supplies:
2.5 oz Cut Away Stabilizer Backing - https://amzn.to/3OPYTPR
1.8 oz Tear Away Stabilizer Backing - https://amzn.to/3zRm3B2
Magna-Glide “L” Bobbins - https://amzn.to/3cW7yTt
GROZ-BECKERT Needle (Titanium) - https://amzn.to/3vxRWw4
Madeira 5,500yd Polyester Thread - https://amzn.to/3vObAns
Fiskar Curved Scissors - https://amzn.to/3zPupt1
Might Hoop System - https://www.mightyhoop.com
Madeira Threads - https://www.madeirausa.com/

🛠️ Equipment I use:
Sony ZV-1 Digital Camera - https://amzn.to/3ShlnfJ
SanDisk Extreme 128 GB MicroSD Card - https://amzn.to/3BElLz3
Neewer Ring Light - https://amzn.to/3QbpPKP
Rode Wireless Go II - https://amzn.to/3PQ4aIq
FTF Gear Lapel Mic - https://amzn.to/3Q9taKE
Wire Storage Shelf 48”x18”x82” - https://amzn.to/3SlBnNu
Canon IX6820 Printer - https://amzn.to/3BJO2nw

🕛 🕛 VIDEO CHAPTERS 🕛 🕛
00:00 – Materials Used
00:33 – Setup
01:20 – Embroidery
02:04 – Cleanup

📝 Detailed Breakdown:
For this project, we will be floating our tie in the 5.5” mighty hoop which is a process where the item being embroidered will not be secured in the hoop. Instead, we secure the tie onto the stabilizer using tape. The stabilizer of choice is two sheets of 3 oz tear away stabilizer. I typically use cut away for anything being worn but due to the design size and ties not needing to be washed often, I have chosen a tear away for a clean back side of the tie. To get the hoop prepared, I lay the two sheets centered on the bottom Mighty Hoop then allow the top hoop magnetically clamp the stabilizer into place. Once in place, I center the tie and use painters’ tape to secure it to the stabilizer. After this is ready, the tie is placed onto the embroidery machine and centered once more with the machine’s laser. This embroidery process is very quick as it is just two letters. Once done, you can simply tear away the two sheets of stabilizer (one at a time) and the tie is ready to go!

FULL DISCLAIMER: I make a small commission on my amazon affiliate links