Proffie 2.2 Install into 89 Sabers/Korbanth MPP
Автор: Megtooth Sith Sabers
Загружено: 2021-09-19
Просмотров: 5708
Описание:
Video only shows wiring the Proffieboard into the chassis, not the complete install. Switch PCB wiring, Power Switch, and Hilt side PCB wiring/installation are not shown, but I have other similar videos showing that. This saber used standard TCSS 11 Pin Hilt Connector, High Amp KIll Switch, and I used the stock onboard PCB for the activation and Aux Switches. I combined the GND pads on the PCB with a bridge, and then wired the uncommon side to the individual activation/auxiliary switch wires. Blade socket was WAAAAAAAAY too tight for a 1" blade, so I had to hone it out. Saber uses Goth Padawan MPP Chassis with a Keystone 18650 battery holder for removeable battery set up. Chassis secured into hilt via 8-32 retention screws.
Switch Video: • Lightsaber Switches Introduction
Hiltside PCB Video: • Neopixel Hilt Adapter
Hilt Tapping: • General Hilt Tapping for Set Screws, brass...
New Blade Building Video with KR Pixel Stick: • Killer Neopixel blade build 2. Using KR Sa...
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
