3rd Final update Incra fence dust collection retro fitting

Описание: This is my 3rd and final edit of this video. At 7:35 in this video I added content to help answer any questions that you may have in regards to the brackets. I hope this will help.
To keep everything uniform I used bolts and T-nuts from Incra part 18, part# PTSL-800200.
Here is a link to Incra for the T-nuts and bolts:
https://www.incrementaltools.com/PART...

My first video should not of been posted. I for got to cancel it. the 2nd edit had too many negative comments and questions. This 3rd and finial edit should hopefully answer any questions regarding the brackets.
This is an update the the first attempt to retro fit the above blade dust collection on my Harvey Tables saw to the Incra fence system. This update is far better than my first attempt. The positioner can slide to the rear stop with out any obstruction. Almost looks factory. If you have any questions Please ask in the comment section below, Or email me direct [email protected]. Thank you and enjoy.

Take you table saw to another level with rust protection. Click on the link to visit Carbon Method and give your table saw the protection it deserves:
https://carbonmethod.com/

Click on this link to purchase your very own Incra Precision Table Saw Fence:
https://www.incrementaltools.com/defa...

If you like to score some of the tools used in this video just click on the link next to each tool below and help support this channel.

Score you own Lufkin 16' tape measure here:
https://www.amazon.com/dp/B07P9VZHJD?...

iGauging Digital Calipers:
https://www.amazon.com/dp/B0848WQNBQ?...

Milwaukee 29 Pc. Cobalt Red Helix Drill Bit Kit:
https://www.amazon.com/dp/B082345X45/...

Check out my amazon store and help support this channel. Click on the link below:
https://www.amazon.com/shop/theshack

Thank You for viewing, Subscribe and Like

Follow me on twitter: rick@backintheshack

Check out My Channel:    / theshackhome