Slag Removal, Edge Rounding and Oxide Removal - DM1100 DCC - Deburring Machine

Описание: The new DM1100 DCC machine has three stations: Slag Removal, Edge Rounding and Oxide Layer Removal. See full details here: https://metaldeburringmachines.blogsp...


Complete DM1100 DCC Deburring Machine:
1) D – deburring drum for slag and burr removal;
2) C – cross belts for edge rounding;
3) C – cross belts for oxide layer removal. See here:

► Slag Removal
Burrs are grinded away from the edges with a powerful contact drum. This deburring drum has a large diameter with an extra soft rubber of 20SH for heavy burrs and thick material. The dry concentrate the pressure in the edges where the slag is located, leaving the surface of the material slightly touched only.

► Edge Rounding Station
The edge rounding station consists of a set of two counter-rotating edge rounding cross belts. The opposite rotation enables the edge rounding of all the contours: inside and outside. The result after this station is a soft edge.

► Oxide Layer Removal
Automatic solutions are efficient when it comes to removing the oxide layer: the production rate is closer to the laser’s production rate and cost, and maintenance is not demanding when compared to using nitrogen to assist the laser. You can get consistent results in all the edges and laterals of metal parts. Oxide Layer Removal

At the end of the video, it is possible to see a complete return table in order to allow a single operator process with a complete return system that is suitable for small, large, light, or heavy metal parts. See more about this system on our website: https://nsmaquinas.com/large-parts-co...

For more information on this machine, email us at [email protected] or visit nsmaquinas.com and fill in our contact form.