Replacing the Driver & LED on WF-501B - NANJG 105D AMC 7135 x 8

Описание: Thank you for watching my video! Hope you liked it. If you'd like to support my channel, please check out my affiliate links below, thank you!
Or if you'd like to buy me a pizza, yum!: https://www.buymeacoffee.com/yuwadecu
My Patreon page may also interest you:   / davidsunshine867  
Check out my AMAZON.COM store for cool stuff: https://www.amazon.com/shop/davidsuns...

UPDATE, I now recommend the Astrolux X5/X6 FET+7135 driver (http://tidd.ly/40dec322)
This driver has a MOSFET to pass a lot of current to the LED, and a programmable temperature limit, I currently use it in all my 18650 flashlights; it works very well in the Convoy S2+, but will need an LED on a copper MCPCB board. If you don't want to upgrade the LED board to copper, I would recommend the Biscotti 7135 x 8 driver (https://www.aliexpress.com/item/32968....

Below are my current flashlight and battery recommendations:
Great utility light - Convoy S2+: http://tidd.ly/34d41a3b (Gearbest) or http://tidd.ly/ebeb0235 (Aliexpress)
Great thrower, C8+ SST40: http://tidd.ly/cfc20b5c (Gear) or http://tidd.ly/70d8e (Ali)
A beast of a search light is the Convoy L6 5000K: http://tidd.ly/67418ad1 (Gear) or http://tidd.ly/fc3cb6a1 (Ali)
If you want a whole package, headlight with battery and built in USB charger, the Sofirn SP40 (http://tidd.ly/905d3356) fits the bill, and is only $24.99, with built in temperature control! (Best deal of them all, my favourite light at the moment).

Recommended Chargers and Batteries to run your high powered/high quality flashlights:
Liitokala Li-PD4 Charger: http://tidd.ly/e00cdc07 - GEARBEST
Liitokala 18650: http://tidd.ly/a64011e5 - GEARBEST
26650 5000mAh - http://tidd.ly/2f121cb0 - GEARBEST

Littokala Li-PD4 Charger: http://tidd.ly/d8c9d773 - ALIEXPRESS
18650 LG MJ1 - http://tidd.ly/51d0398 - ALIEXPRESS
26650 5000mAh - http://tidd.ly/4853bd8a

Old Nanjg 105D Driver Information: By replacing the driver with a 105D, you can have two different groups, on-time memory, and access to strobe and SOS only when you need it.
The pulse width modulation frequency is also much higher, so you won't see strobing when there's motion, or a fan.
Each 7135 current limiter passes 350mA, so with 8, you get 2.8A
If you want less current for lower power and higher runtimes, use the 4 chips(7135 x 4) or 6 chips (7135 x 6), or even less.
The Nanjg uses an Atmel ATTiny13A, which can be custom programmed with an Adruino, so if you have a programmer, you can make custom programs.
A similar driver can be be purchased with pre-flashed firmware of your choice, at sites such as mountain electronics, if you don't want to flash yourself.

Hope you enjoy my channel, please support it by using my affiliate links above, it's much appreciated!

Thank you for your support.