Votator® II Scraped Surface Heat Exchanger Maintenance Procedures - WCB

Описание: This 40 minute video will show you how to perform routine maintenance on your Votator® II Scraped Surface Heat Exchanger to ensure peek operating efficiency. This video will teach you the service procedures necessary for replacing the blades, seals and elastomers as well as removal, inspection and replacement of your heat exchanger tube. Procedures covered in this video include: Removing the Drive End Safety Cover, Removing the Rotary Joint from Locknut, Removing the Plastic Locknut Safety Cover, Removing the Non-Drive End Safety Cover/Bearing Retainer, Remove the Shaft Locknut on the Non-Drive End, Preparing and Removing the Non-Drive End Head, Removing the Non-Drive End Extra Heavy Duty Head, Preparing and Removing the Mutator Shaft, Removal of the Drive End Head, Visual Inspection of Product Tube Components, Removal of Product Tube Components, Installation of Product Tube and Ancillary Components, Inspection of End Head Components Including Seal, Bearing and Elastomers, Installation of the End Head Components including Seal, Bearing and Elastomers, Removal of Rotary Seal Components from the Mutator Shaft, Inspection and Preparation of the Mutator Shaft and Blades, Inspection and Installation of Rotary Seal Components on the Mutator Shaft (2012 Seal Design, One Piece Seal Design, Two Piece Seal Design, Double Mechanical Seal Components), Installation of Drive End Heads and Mutator Shaft, Installation of Non-Drive End Head, Installing the Non-Drive End Extra Heavy Duty Head, Installation of the Shaft Locknut onto the Mutator Shaft, Install the Non-Drive End Safety Cover, Optional Install the Non-Drive End Extra Heavy Duty Safety Cover, Optional Install the Rotary Joint, Install the Drive End Safety Cover, Gearbox Maintenance - Drain and replace the oil.