Baby Tooth Build Guide - DIY FPV Drone - Part 1

Описание: Today we are going to build a variant of KebabFPV's "baby tooth" FPV drone. Just what is a "baby tooth"? It is an ultralight FPV quad which typically runs on 1-2S batteries. It is small, light and very quiet when it flies. Most importantly, it offers a roller coaster flight experience similar to that of a larger, heavier quad.

For more information about this build and a list of the materials I used, check out my detailed article:

https://nuxnik.com/baby-tooth-build

Table of Contents:

00:36 - Bill of Materials
01:47 - Frame Prep
04:00 - Flight Controller Prep
04:43 - Wiring up the RX
05:52 - Wiring up the VTX
06:41 - Wiring up the camera
07:46 - Heatshrink and Insulation
09:15 - Wiring up the power leads and capacitor
11:06 - Wiring up the motor wires
14:16 - RX Antennas
15:57 - Canopy assembly
18:06 - Finishing Touches
20:41 - Final Thoughts
21:17 - Subscribe

I would like to thank KababFPV for the hard work that went into his creative design. If you haven't already subscribe to his channel:    / kabab  

...and while you're at it subscribe to my channel as well. For more builds check out my blog for other build articles: https://nuxnik.com

Join me on Patreon:
  / nuxnik