“Caliburn G3 Pro Unboxing ✨ Next-Level Display Read more in the discprition…!

Описание: The Caliburn G3 Pro is a pod system device with the following key features:
• Battery & Power
 • Integrated 1000 mAh rechargeable battery 
 • Maximum output: 35 W 
• Pod / Coil / E-Liquid Capacity
 • Uses pods with a 3 mL e-liquid capacity (for the 0.4 Ω pods) 
 • Compatible resistance range: ~ 0.4 Ω to ~ 0.9 Ω 
• Display & Interface
 • Features a full screen / LCD display showing vaping details (battery, wattage, etc.) 
 • Offers both button firing and air-activation modes 
• Physical Dimensions & Build
 • Dimensions: approx 123.5 × 27.8 × 16.8 mm 
 • Net weight: ~ 92 g 
 • Body materials: Zinc-alloy (or metal body) with plastic / PCTG for pods 
• Charging & Other
 • USB-C fast charging (2 A support) 
 • Modes & locking: You can switch between button and air modes, and lock the fire button. (Double-press toggle) 

⸻

🛠️ How to Use the Caliburn G3 Pro

Here’s a step-by-step general guide (based on the user manual / typical procedure). Always refer to the official manual for safety and specifics. 
1. Unbox & Inspect
 Take out the device, pod(s), USB-C cable, and any accessories. Make sure everything is in good condition.
2. Install Pod & Fill E-Liquid
 - Remove the pod from the device (usually by magnetic pull or slot).
 - Locate the fill port (often a silicone plug or flap).
 - Fill the pod with your e-liquid (be careful not to overfill).
 - Replace the seal / plug, ensuring it is closed properly.
 - Let the pod sit for a few minutes (5–10 mins) to allow the coil to prime (wicking).
3. Insert the Pod
 Push the pod back into the device; it should click or magnetically snap in place.
4. Power On / Off
 Usually pressing the fire button 5 times rapidly toggles power on/off (common in Uwell devices) 
5. Mode Selection & Lock / Toggle
 - To switch between button mode and air-activation mode, press the fire button twice within 2 seconds. 
 - You can lock or unlock the button ignition in that same way (double-press). 
6. Adjust Wattage / Settings (if applicable)
 Use the interface on the display or control buttons (if present) to raise or lower wattage up to max (35 W).
 Check your pod’s resistance and choose a setting appropriate for it.
7. Vape / Draw
 - In button mode, hold down the fire button while inhaling.
 - In air mode, just inhale and the device will trigger automatically.
8. Charging
 When battery gets low, plug in via USB-C. The display usually shows charging progress. Avoid overcharging and always use suitable cables/chargers.
9. Maintenance & Safety
 - Replace pods/coils when flavor degrades or you get dry hits.
 - Clean connections and make sure nothing is leaking.
 - Do not overfill, avoid chain vaping beyond device limits, and always follow safety instructions in the manual.

#abrixcloud
#vape #pod
#Abrix
#eliqiud
#newpod
#vapesmoke