CNC owners overthink this part

Описание: If you're ready to install a wasteboard for your Onefinity CNC, this might lend some insight. The reality is, you need the wasteboard to prevent your bit from cutting into your table. Every now and then, this wasteboard will need to be replaced depending on how frequently you mark it up.

Check out Onefinity here: https://www.onefinitycnc.com/?ref=OAK... to see everything they have to offer and support my small business. This is an affiliate link and I do earn commission on CNC purchases made through this link!

I kept mine simple by marking the corners for where the router reaches furthest and then drew lines with a straight edge to mark the cutting area. I knew I wanted one piece of T-track in the center so subtracted 3/4" from my overall cutting area width and divided the remaining space by two to give me two rectangular pieces of MDF as my wasteboard. I put a piece of T-track in the front as well thinking this would allow me to hold down two sides of most pieces I work on. I only had two pieces of T-track on hand so I just used what I had. Drywall screws were used to fasten down the MDF wasteboard nice and snug and I did pre-drill countersunk holes to make sure the screws went down pretty far so that I wouldn't hit them when flattening the wasteboard.

Thanks for checking out the video today! Christy can also be found:
Instagram @oakhillmillworks -   / oakhillmillworks  

Facebook @oakhillmillworks - https://www.facebook.com/profile.php?...

TikTok @oakhillmill - https://vm.tiktok.com/ZM8WGd5h6/

   / @oakhillmillworks  

Website https://www.oakhillmillworks.com


Affiliate Links:

Shown in this video:
Bucktool Dust Collector (DC50) - https://amzn.to/3DW7cUU
Makita Trim Router - https://amzn.to/3p05MV0
Powertec T-track & clamps - https://amzn.to/3mbQNWi
DeWalt Table Saw - https://homedepot.sjv.io/ORzOjA


Support Christy's Small Business Journey by Shopping through her links below!
Shop with Taylor Toolworks https://lddy.no/131nk & use XTRACT10 for 10% off your purchase of any 3M cubitron or Xtract abrasives! Sign up as as member to get free shipping at $50.
Shop my respirator set-up for paint and/or dust: https://lddy.no/13322
Shop on Amazon - https://www.amazon.com/shop/oakhillmi...
Shop Home Depot - http://homedepot.sjv.io/P0KRPX
Shop BAD North America - http://badnorthamerica.com & use OHM10 to save 10%
Shop ZAR finishes - https://www.zar.com/products/zar-inte... & use OHM10 to save 10%

#woodworking #cnc #diy #laser #smallbusiness #womenempowerment #oakhillmillworks