How to read 2-pin Peugeot 306 fault codes. Using Haynes PFCR, test light, oscilloscope.

Описание: Reading diagnostic flash fault codes for a 1996 Peugeot 306 using a Haynes PFCR, a test light or an oscilloscope. This car has a Bosch Motronic MP5.1 engine management computer and a 1.6 litre TU5 JP (NFZ) engine.

This type of fault code indication was quite common in PSA Group vehicles (Peugeot and Citroen) up until around 1997.

In this video I attempt to describe the flash code system, show how to use a Haynes PFCR professional fault code reader, a test light and oscilloscope to read these codes and show these devices in use.

Read more about the subject here: http://www.instructables.com/id/Readi...

The video contents are as follows:
0:00 - Introduction
0:23 - Methods
0:52 - Code reading procedure
2:27 - Code examples
3:28 - Equipment used
3:31 - Haynes PFCR overview
5:07 - Test lamp overview
5:45 - Oscilloscope overview
6:22 - Location of the DLC connector
6:36 - Performing the readings
6:39 - Bonus battery check
7:12 - PFCR procedure
8:23 - Test light procedure
9:13 - Oscilloscope information
9:50 - Summary

The following codes are possible with this engine management computer:
11: End of codes
12: Beginning of codes
13: Intake air temperature sensor or circuit
14: Engine coolant temperature sensor or circuit
21: Throttle position sensor or circuit
22: Idle speed regulator
31: Oxygen sensor or circuit
33: Manifold absolute pressure sensor or circuit
41: Crankshaft position sensor or circuit
42: Injector or circuit
51: Oxygen sensor or circuit
52: Mixture control, supply voltage, air or exhaust leak
53: Battery voltage incorrect
54: ECM failure

I hope this is useful to someone.
Thanks for watching.