How to Install Air-SS-2 Aerial-Mounted Snow Sensor

Описание: Learn how to install our AIR-SS-2 Aerial-Mounted Snow Sensor for an electric snow melt system. The Aerial-Mounted sensor detects ambient temperature and precipitation - activating the outdoor system only when snow or ice is present. This aerial sensor is compatible with snow melting systems for outdoor surfaces or roof and gutter deicing systems. The unit will not work unless it is attached to a compatible snow melt control (SCP-120 or SCA-DUAL).

Learn more about the Aerial-Mounted Sensor: https://www.warmlyyours.com/en-US/pro...

Learn more about Snow Melt Controls:
https://www.warmlyyours.com/en-US/sno...

If you've purchased this product, be sure to review the checklist before installation:
https://www.warmlyyours.com/en-US/pub...


The sensor should be installed in an area where snow normally accumulates. Make sure there is a path for both the pipe and the sensor wire to run from the installation spot back to the control indoors.


Supplies needed:
Aerial-Mounted Sensor
Waterproof box and cover
PVC pipe
Glue for waterproofing
Extension cable - 18 gauge
Screwdriver
Box cutter

Assemble the sensor and housing using the supplies above, following the instructions in the video or the installation manual.

Test the sensor using a cup of water and a can of compressed air - ensuring the moisture and temperature sensors trigger correctly - you will hear the controller click on when activated by the sensor.