How to Make a Simple Arduino Battery Tester

Описание: In this video, I go through the steps of making a simple Arduino battery tester. If you’re looking for a simple yet effective way of testing a battery’s charge, then be sure to check out this project.

Full Tutorial: http://pimylifeup.com/arduino-battery...

If you’re looking for a complete equipment list for this tutorial, you can find it below. We may earn an affiliate commission if you buy through our links.

Arduino Uno: https://amzn.to/4bQkFyM
Breadboard: https://amzn.to/4bLzVwX
Breadboard wire: https://amzn.to/44SJhVq
3x 100-ohm resistor: https://amzn.to/3VaYMos
2.2k ohm resistor: https://amzn.to/3V9q7at
5v1 Zener Diode: https://amzn.to/3KcCgFj
LEDs: https://amzn.to/3KdsEKI

The code for the Arduino battery tester is straightforward. We take a reading from the analog input and convert it to a voltage. We then compare this to our defined values and turn the relevant LED on.

To test it out, turn the Arduino on and then hook the analog wire to the positive end of the battery and the negative wire to the negative end. Once hooked up, the Arduino should light up the relevant LED. If it doesn’t, you will need to do some troubleshooting.

I hope that you find this Arduino battery tester tutorial helpful.