SY-4X Syncussion 1.0.2 Update Plug-In VS SY-1 Hardware - Raw Test 2

Описание: https://www.alyjameslab.com/alyjamesl...
New test using 1.0.2 update (to be released this week). Matching as best as you can match 100% analog vintage hardware.

Change Log - v1.0.2
Fix - MIDI-learned parameter (if any) assignments are now correctly saved with the session.
Fix - MIDI Custom Map for channels 6, 7, and 8 are now properly assigned to custom drum notes.
Fix - Sweep Envelope now correctly updates EG2 decay time (corrected missing update from tuning to EG2).
Fix - Trigger velocity now correctly affects EG2 decay time.
corrected envelope calculation.
New Feature - Copy and Paste channel settings, allowing users to easily share settings between channels or copy/paste between presets.
Added - New parameter: VCF Poles 1:1 Ratio.
optional equal resistance for the filter's CV resistors, makes the Spread parameter even more interesting by bringing poles closer.
Added - New parameter: LFO Trigger Reset (resets LFO phase on trigger).
thanks to DSP this mod still keeps S&H unaffected.
Added - New parameter: EG Fast Attack.
bypasses envelope attack smoothing for a sharper, more "clicky" sound, adjust as needed. Set to "Hardware Reset" default.
Added - New parameter: Decay Sense.
an extra custom control to increase dynamic decay control, without this extra control there is still a slight decay change from trigger envelope but now you can increase it independently.
Tweak - Sweep Envelope now outputs a clipped voltage when set to extremely fast, simulating OPAMP driven close to supply rail more accurately.
Adds a noticeable short "tuned snap" at the beginning of an ultra fast sweep that was missing before.
Change - Hold reset value changed, also reflects when using "Hardware Reset".
-default EG2 response is now closer to hardware with that setting - a bit less curvy than previously set default value, tweak to taste.
Tweak - Minor GUI changes to accommodate for new LFO sync param and additional settings.
-Mode Trigger switch is now closer to the left-side Mode knob & CH8 Custom Mode A switch has been moved to the right. Set panel redesigned accordingly.
Tweak - Minor GUI changes: Some GUI sliders response change: Log taper instead of Linear.
I say some because for example, I have kept LFO sliders Linear because it's easier to control that way, the log response makes sense on some parameters and in case you were used to the hardware it will make the experience more familiar even though some parameters have extented range.