Cannonkeys Chimera 2R SE

Описание: 1. Board
Chimera 2R SE
Designed by Upas of Cannon Keys

2. Plate
Aluminum (Full)

3. Keycaps
Lin Works BoW

4. Switches
SWK x OUTVA Yang
Spring : GEON 18mm 62g (lubed with GPL105)
Stem lubed w/ Krytox GPL 205g0
Film : N/A

5. Foam
N/A

6. moding
replace bottom poron gasket from stock to 2t softer poron
detach upper side gasket and use TX 0.2t silicone gasket tape
fuxk you Cannonkeys


I'd love this board's design so much but also have lots of digusting comments on this board.

first of all, Chimera has a designed issue. the middle of case swells up cuz there's not enough space for poron gasket & plate thickness. so when the upper case & bottom case are screwed together, upper one gets swelled up.
even there are only 4 screw hole, each corners, so not enough force to fasten upper case without swelling.

it's completely Cannonkeys' fault then I mailed this matter to them, but they said it's same as 1R and no way for compensation and nothing to cope with this problem. just detach your upper side poron gasket! that's all.

Did they show 1R to me before 2R GB? how could I realize such problem with some renders, their promotion youtubers' blarney clips?
Or, did they notice such digusting problem to GB participants?

Do you think I care about 2R is same deign with 1R? if so cannonkeys must make solution for 1R & 2R both.

Are you saying that because the design of a keyboard I've never actually used is the same as round 1, the should I just shut up and use this $700 flawed keyboard? are you sure?

at least cannonkeys tried coping with this problem on their side. for example, send thinner gasket. I've never expected that they would make replacing upper case with deeper space.

But they did the worst possible thing. just they passed the buck to consumers.

I'm not the only one, most Korean buyers complained about this issue. It varies from person to person, but there is a height difference of 0.8mm to 1.5mm.

so I replace the bottom side gaskets more soft and change the upper gasket material from poron to TX 0.2t silicone gasket tape. then the front height gets flat.

I swear never buy sth from this motherless vendor, cannonkeys. fuxk you.