Rtint Mirror Signal Wrap Installation

Описание: How to Install Rtint Mirror Tint

If you have a mirror with a signal indicator and you want to add a touch of tint and sophisitciation, our Rtint Smoked Mirro Wraps are just the thiing. Check out the basic installation steps below:

1.Prepare and clean
2.Spray and lubricate lenses
3.Remove liner
4.Alight and apply tint
5.Spray tint
6.Squeegee on tints
7.Heat the tints
8.Trim away excess
9.Allow to cure and pop any bubbles
10.Enjoy!

——Recommended Tools——
Rapid Prep
Rapid Tac
Rapid Clear
Squeegee
Razor Blade
Heat Gun or Hair Dryer

—Installation Tips—
•Ideal application temperature range is between 70º to 80º F (21º to 27º C).
•When possible, turn on your lights to help increase the surface temperature.
•Surfaces must be clean and dry prior to application.
•When removing precut smoked tint pieces from the backing it is best to continuously spray both sides of the film with an application fluid such as Rapid Tac or a 10:1 water to mild soap solution to prevent premature adhesion of the kit to itself.

•Clean your areas thoroughly with a solution such as Rapid Prep.
•Use masking tape to test for adhesion.
•If masking tape curls up and falls off you need to continue cleaning.
•Do not apply during periods of high relative humidity (i.e., when it’s raining).
•Do not bend vinyl film back and forth as this causes the adhesive to wrinkle when applying.

Get yours here: https://www.rvinyl.com/tint-film.html

#Rvinyl #MirrorSignalWrap #InstallationInstructions #Rtint #Audi #Q& #BlackoutTint