Learning To Longboard: Sector 9 Sidewinder Trucks: Best Surf Style Set-up!

Описание: Get Your Bushings Here: https://amzn.to/3bRVgvo

If you're a longboarding enthusiast looking to take your carving and diving experience to the next level, you'll want to pay attention to your setup. In this article, I'll be sharing some setup tips that can help you achieve the best riding experience based on your weight and make your longboard trucks carve and dive when you pump over long distances. Specifically, we'll be looking at the Sector 9 Gullwing Sidewinder Trucks, which are known for their double kingpin design that allows for maximum lean and turn.

When it comes to setting up your Gullwing Sidewinder Trucks, it's important to find the right balance between looseness and resistance. You want your trucks to be loose enough to turn easily, but not so loose that you feel like you're riding on jelly. The key to achieving this balance is in your bushings.

Bushings are a crucial component of your truck setup, and choosing the right Durometer bushing for your weight is essential to getting the most out of your Gullwing Sidewinder Trucks. Durometer is a measurement of the hardness of the bushing, and it's indicated by a number followed by the letter A. For example, 78A is a softer bushing than 98A.

To determine the correct Durometer bushing for your weight, you'll need to refer to a bushing chart. These charts typically list a range of weights and the corresponding Durometer bushings. For example, if you weigh between 120-180 lbs, a bushing with a Durometer of 85-92A might be appropriate.

Once you've selected your bushings, it's time to install them. Make sure to remove the old bushings and clean the truck baseplate before installing the new ones. You'll also want to use a bushing washer on both sides of the bushing to ensure a secure fit.

After installing your bushings, it's time to fine-tune your truck tightness. To achieve the best carve and dive feel, you'll want to start by loosening your trucks until they're just tight enough to keep you stable while riding. From there, gradually tighten them until you reach a point where they offer enough resistance to give you a solid feel as you lean into your turns.

It's important not to over-tighten your Gullwing Sidewinder Trucks, as this can restrict your movement and potentially damage your bushings over time. As you tighten your trucks, make sure to check that the lock nut is appropriately engaging with the thread to avoid any potential loosening.

Overall, finding the right setup for your Gullwing Sidewinder Trucks takes some trial and error. But with the right Durometer bushings and a careful approach to tightening, you can achieve a ride that's smooth, stable, and optimized for carving and diving. So get out there, experiment with your setup, and enjoy the ride!