Spessori del fondo parte terza - Lavorazione a pialletto

Описание: Index of videos : http://davidesora.altervista.org/

ENGLISH TRANSLATION of the written notes in the video, in order of appearance :

00:05 - Back plate thicknesses part three - Fingerplane working

00:19 - Remove all the marks of the gouge by progressively thinning the thickness starting from the upper and lower bouts and then the center, until you reach the measures shown in the image

03:58 - Use a fingerplane with a toothed blade to work in any direction without tearing the wood, obtaining a better visibility of the cuts and a greater uniformity of working

09:52 - Check from time to time the notes emitted to the percussion, observing the progressive lowering of the frequency, the increase in the volume of emission and the improvement of the quality during the thinning of the thicknesses

12:22 - At this stage of the working the highest note emitted to the percussion (mode 5, percussion and listening at the center of the back) should be around Sol (G)
If it were even higher, the thicknesses will be lowered further, whereas if it were to be reached previously with thicknesses still high it will be advisable to stop and start the scraper finishing.

12:39 - Evaluate also the yielding to the bending in the various directions, to get an idea of the stiffness of the back, trying to perceive the uniformity or any discontinuity to the bending. Use caution by evenly distributing the applied force to avoid ungluing the central joint