Routing through the Fridge Vent! -- Running solar & antenna wires through the RV refrigerator vent!

Описание: SEE DESCRIPTION BELOW FOR CHAPTER/STEP TIMINGS.

Getting wires from the roof into your RV can be a pain... and routing your cabling through the refrigerator fridge vent is a popular way to avoid making holes (leaks!) in your roof. (FYI This video is part of a multipart series on installing a cellphone booster on my trailer...)

In this video, I go into (excruciating) detail on how to route cables through the vent. That includes cleaning the roof, drilling in the vent, using a cable gland, and strain relief. I did this work as part of a installation of a WeBoost Drive X RV cell phone booster, but the same process is used if you're routing any sort of cable, including solar wiring or other antenna wiring.

This is a long video, so here are some points to punch in:

-- Why I placed my antenna where I did -- 0:30
-- Removing the "fin" around the fridge vent -- 2:25
-- Exactly where I'm going to drill through the vent -- 3:42
-- What's a cable gland? -- 4:03
-- Drilling! -- 5:40
-- Installing the cable gland in the hole -- 6:39
-- Routing the wire through the hole -- 7:57
-- Antenna placement with sticky tape -- 9:08
-- Assembling the WeBoost antenna and connecting the cable -- 10:17
-- Replacing the refrigerator "fin" -- 14:09
-- Strain relief on the antenna cable -- 16:08
-- OVERVIEW OF COMPLETE INSTALL -- 16:30
-- Caulking with Sikaflex 221 -- 17:38
-- Final view of the Antenna in place. Sputnik lives! -- 20:25


Here are the key materials used:

WeBoost Drive X RV Cell Phone Booster:
https://amzn.to/2ERI2L7

CB Radio Antenna Mount:
https://amzn.to/34VNln5

THIS ANTENNA MOUNT MIGHT BE A LITTLE BETTER:
https://amzn.to/2YgRsZS

3M VHB Tape (used to mount all components... no screws!)
https://amzn.to/2Stqug5

GREAT TIP FROM A VIEWER: "The only piece of advice that comes from my Ham Radio experience is to put some connector sealant tape on the connection from your antenna to the wire going inside. Otherwise water will get into this connection and corrode it causing loss of signal. It can also get into the wire and cause you to have to replace your wire entirely."


Let me know if you have any questions or comments.... I hope this helps!